Aluminum Radiators!

Tags

Aluminum Radiators!

LS SERIES 62-67 $800.00

P/N ENT 9440-LSX

This is our 1962 – 1967 Nova aluminum radiator for swapping a LSX based motor (LS1, LS2, LS3, LS7, LQX truck motors, etc) into your car and is configured with both hose connections on the passenger side, meaning these are a DUAL PASS system. Includes dual HP fans and aluminum shroud. This radiator has brackets that attach to the side of the radiator (not shown) and bolt to the core support in the stock mounting holes. Also included is the aluminum shroud with high powered 11.5″ paddle blade fans (not the cheap lower powered fans) delivering a TRUE 3000 CFM. Together, they pull 35-40 amps (check the current rating on the cheapy fans that claim to pull high CFM). Unless specifically requested, we now install the steam vent port on the passenger side below the upper hose connection. We also add a 3/8″ NPT bung on the passenger tank as well for a temp switch or for installing a sending unit for a temp gauge.

This will fit with stock front suspensions as well as aftermarket front suspensions such as the bolt on front clips. For the upper hose, a 1990 – 1995 Eclipse upper hose is almost a perfect fit.

Like all of our radiators, it’s made with pride in the USA with USA made cores. Unlike most radiators, our cores are purpose built for high performance cooling and are not made using standard passenger car (PC) cores. All of our radiators are fully TIG welded, 2-rows of 1.0″ tubes, use heavy duty transmission coolers, no epoxy, a billet filler neck, brass overflow connections and a brass drain cock.

This radiator is hands down the best performing, fitting radiator made for our precious Nova’s. I run these radiators in all of ourĀ  Nova’s here at Church Boys Racing…..and Made in the USA!!!

 

Small Block Chevy

SBC 62-67 $740.00

P/N ENT-9440-SBC

This is our 1962 – 1967 Nova aluminum crossflow radiator for a SBC/BBC motor. It includes dual HP fans and aluminum shroud. This radiator has brackets that attach to the side of the radiator (not shown) and bolt to the core support in the stock mounting holes. Also included is the aluminum shroud with high powered 11.5″ paddle blade fans (not the cheap lower powered fans) delivering a TRUE 3000 CFM. Together, they pull 35-40 amps (check the current rating on the cheapy fans that claim to pull high CFM). Unless specifically requested, we now install the steam vent port on the passenger side below the upper hose connection. We also add a 3/8″ NPT bung on the passenger tank as well for a temp switch or for installing a sending unit for a temp gauge.

Please check your clearance. You will need 7″ of clearance from the core support to the water pump pulley for this to clear. Long water pumps with the March style serpentine system will require a special low profile fan setup to clear. Short water pumps with the March style setup can still use our standard HP fans with a shroud modification. If you’re in the planning stages of yoru project, we highly recommend going with the short water pump setup.

Like all of our radiators, it’s made with pride in the USA with USA made cores. Unlike most radiators, our cores are purpose built for high performance cooling and are not made using standard passenger car (PC) cores. All of our radiators are fully TIG welded, 2-rows of 1.0″ tubes, use heavy duty transmission coolers, no epoxy, a billet filler neck, brass overflow connections and a brass drain cock.

Comments are closed.

Copyright © 2017 churchboysracing.com. Designed by BigTuna Interactive.